INCODE TI3134 Half-inch Yellow water-based ink cartridge for TIJ inkjet printer
Product detail
INCODE TI3134 Half-inch Yellow water-based ink cartridge for TIJ inkjet printer
Water based ink for coding and marking
Features
1. Specially designed for permeable materials such as cartons, with good fluency.
2. High contrast and saturated colors.ink is suitable for coding and marking on permeable materials such as cartons
Transportation and Storage
Before use, the toner cartridges must be placed in a vacuum bag.
Use the toner cartridge within two weeks of removing it from the vacuum bag for best printing results.
Cartridge clip cap when not in use with the mouthpiece up or in a horizontal position.
For more information, consult the Material Safety Data Sheets (MSDS).
Precautions for ink cartridge sleeve and ink cartridge unpacking and shelf life
1. The best printing distance: It is recommended that the nozzle surface and the surface of the object to be printed should be kept within 3mm. Note: The recommended printing distance for some high-performance smart inks is 0.5~1mm.
2. The best ambient temperature of the ink cartridge is 5~30% and the humidity is 30%~60%.
3.The wiped cassette should be put into use immediately;
4.If it is not used immediately, please cover it with a ferrule to prevent the nozzle from drying and causing the nozzle to be temporarily blocked.
Common problems and solutions
[1]What should be done about the use and maintenance of water-based ink?
Water-based ink wiping: spray an appropriate amount of distilled water on the non-woven fabric; flatten the non-woven fabric, with the nozzle facing down, gently and slowly wipe the nozzle in the direction shown in the figure; if the nozzle is severely blocked, it still cannot achieve good spray after wiping To get the printing effect, soak the cartridge nozzle in warm water of about 30°C for 5 minutes, and then wipe the nozzle with a clean non-woven fabric moistened with distilled water;
Other reasons that may lead to poor printing results
1. The distance between the nozzle and the surface of the printed object is too far, resulting in unclear printing effect. The recommended distance is 2-3mm.
2. Electrostatic interference.
3. If the printing parameters are not set properly, please set the parameters according to the ink cartridge label.
For more questions, please contact us.